+ErgoCan EC1119 Installation Download

Page: 3 / 4

STEP 2

Insert assembled riser/bracket into bin

1. Measure panel length,
then mark a line with a pen
on the panel.
(See Panel Cut List above.)

2. Cut panel with utility
knife along the line

1. Slide cut panel into tracks

2. Slide riser/brackets into tracks

note: apply even pressure so
riser slides in straight/even

1. Remove Lid

2. Remove Panel

CUT PANEL

EXAMPLE

EC1119 SHORT PANEL

20”

Marking

Line

EC1119
EC1119
EC1818
EC2626

SHORT PANEL

LONG PANEL

20”
19”
19”
22 ”

PANEL CUT LIST

PAGE

Summary of Contents for EC1119

Page 1: ...818 EC2626 SIGNBOARD INSTALLATION Utility Knife Required Short Bracket Riser Sign Board Frame 11 Fastners 11 Fastners 11 Fastners Short Bracket Riser Sign Board Frame Long Bracket Riser Sign Board Fra...

Page 2: ...brackets added 1 Slide the bracket over the riser holes 2 Snap brackets onto holes 3 Insert fasteners into holes EC1119 Long Side STEP 1 EC1818 EC1119 Short Side EC2626 Use long brackets 8 Fastners 8...

Page 3: ...2 Cut panel with utility knife along the line 1 Slide cut panel into tracks 2 Slide riser brackets into tracks note apply even pressure so riser slides in straight even 1 Remove Lid 2 Remove Panel CU...

Page 4: ...ame through open end of frame Attach the signboard frame by inserting signboard frame onto riser tabs shown by arrows through the slots on the signboard frame Push frame down into the narrow part of t...