11
–
The LED light will turn on when the button up
or down
is used.
–
indicates the state of the battery (see section
2.5)
–
constant hold will move the lifter in
the desired direction
–
release to stop.
–
Used to reactivate the lifter after the use of
the stop- or lock function. Reset by holding the same
button for 5 seconds. Can also be used to lock all
functions to avoid unintended use by e.g. the client. After
holding the button for 5 sec, the LED
(6)
will turn on and
the function is activated.
–
Used in situations where
it is necessary to lower a client safely in a lift failure. This
button must be held constantly to lower the unit. A “beep”
sound will be heard during this operation, the movement
will start after approx. 5 sec.
Hold up or down button if Luna is in sleep mode
–
this button stops all functions immediately
(this can be reset by holding the reset/lock button for 5
seconds).
