General
10
1
2
3
4
5
6
7
8
9
10
11
1.3 Export
We must point out that these sunbeds are intended for the European market only and
may not be exported to the USA or Canada and operated there. No liability will be
accepted if this warning is ignored. We expressly point out that any violation of this may
subject the exporter and/or operator to a high risk of liability.
1.4 Safety
•
=
This sunbed may only be assembled and erected by properly instructed/trained
technical personnel.
•
=
All hazard and safety warnings affixed to the sunbed must be observed.
•
=
None of the safety devices or safety warnings possibly affecting the safe
operation of the professional sunbed may be removed or taken out of operation.
•
=
The professional sunbed must only be operated if it is in perfect working order.
•
=
The professional sunbed has to be controlled by the Ergoline MCS-VI coin
device or a compatible timer (in conformity with the standard EN 60335-2-27).
This timer has to be constructed in such a fashion that the professional sunbed
is automatically shut off no later than <110% of the tanning time selected even if
the control mechanism fails.
Caution!
The safety, reliability and performance of the professional sunbed will only be
guaranteed if:
•
=
It has been assembled and electrically connected in conformity with the German
VDE regulations and it is upgraded or repaired by technical personnel
•
=
and the professional sunbed is used in accordance with these operating
instructions.
•
=
1.5 Care and Maintenance
Danger!
When doing maintenance work that requires opening up the professional sunbed, it has
to be disconnected from the main power supply. Refer to Section 4.3.1.
Care and maintenance play a major part in ensuring that the professional sunbed
satisfactorily meets the requirements made of it. It is therefore essential that you observe
the prescribed maintenance intervals and that all maintenance work and cleaning be
done carefully (refer to section 4.2). Any protective devices/safeguards have to be
replaced after the work has been done.
Please note that the professional sunbed must be inspected by our after-sales
department or a licensed technical company every 12 months (starting from putting it into
service) in order to keep it in proper operating condition.
Caution!
•
=
Only genuine Ergoline parts of the same type should be used. The use of other
parts will invalidate CE Conformity!
•
=
In the event of damage or injury demonstrably resulting from the use of non-
genuine Ergoline spare parts, the manufacturer shall be excluded from all
liability.
Summary of Contents for Classik 475
