20
ergoselect 1
ergoselect 1
21
6 Operation
6.9 Settings
Some of the device settings are configurable to meet spe‑
cific requirements. The settings will be saved and remain
stored even when the ergometer is switched off.
Use the softkeys on the right and left (
↑
↓
) to position the
bar cursor on
Settings
and confirm the selection with
Select
.
The configuration menu displays.
When all changes have been made, you can exit the config‑
uration menu with the
key.
PC Mode
Ergometry
Manual
Settings
Select
Figure 6 – 17: Main menu
Use the softkeys on the right and left (
↑
↓
) to position the
bar cursor on the parameter to change and confirm the
selection with
Select
.
Settings
Default Mode
Protocols
Contrast
Load Change
Language
Select
Figure 6 – 18: Settings menu
6.9.1 Default Mode
In this menu you choose the default mode activated when
the ergometer is turned on. When first turned on after
delivery, the ergometer will display this menu.
Use the softkeys on the right and left (
↑
↓
) to position the
bar cursor on your preferred default mode and save the
selection with
Select
.
Default Mode
Menu
PC Mode
Ergometry
Manual
Select
Figure 6 – 19: Selecting the default mode
6.9.2 Protocols
Protocols 6 to 15 are user‑programmable (protocols 1 to 5
are fixed, see Appendix for protocol parameter details).
Default values can be entered for the following parameters:
— Basic Load
— Stage Time
— Load Stage (load increase with each stage)
Use the softkeys on the right and left (
↑
↓
) to position the
bar cursor on the protocol to change (No. 6 to 15) and
confirm the selection with
Select
.
Protocols
1. WHO
2. BAL
3. Hollmann
4. STD. France
5. Standard
Select
Figure 6 – 20: Selecting the exercise test protocol to edit
