6 Operation
30
ergoselect 4 / 5
6 Operation
The ergometer is available with different control terminals
which differ to some extent in terms of their functionality.
The following sections describe the control and configura-
tion of the device.
6.1 Speed Readout
A speed readout as well as three LEDs on the control ter-
minal inform the patient of the speed: too slow, too fast
or correct (this readout is located at the top of the P and T
versions of the control terminal and on the side of control
terminal M).
The ranges for the respective speed ratings depend on the
selected load (see chapter 13 “Technical Specifications” on
page 84).
1
2
3
Figure 6 – 1: Speed readout
1
speed low (= patient should pedal faster)
2
correct speed
3
speed high (= patient should pedal more slowly)
Note
If, during an exercise test, the speed drops below
30 RPM, the load reading starts blinking on the
display and the load is reduced to zero.
6.2 Handlebar Adjustment
To adjust the angle of the handlebar, release the clamping
lever
1
by pulling it upwards.
Choose a handlebar angle that allows the patient to sit up
straight and comfortably. When done, push the clamping
lever
1
downwards for secure clamping.
Before allowing the patient to rest the full body weight
on the handlebar, check the clamping as follows:
1
Figure 6 – 2: Handlebar adjustment
1
Clamping lever
Danger
With the ergometer standing firmly, check that
the handlebar is tight by trying to push the
handlebar downwards from above. Adjust the
clamping force of the clamping lever if necessary.
Summary of Contents for ergoselect 4
Page 1: ...ergoselect 4 5 Ergometer Operator s Manual 201000433000 Version 2021 06 01 Rev 04 English...
Page 2: ......
Page 95: ......
