8 Control Terminal P
ergoselect 4 / 5
41
Protocols
Protocols 6 to 15 are user-configurable (protocols 1 to 5
are fixed, see chapter 13.5 “Exercise Test Protocols” on
page 87 for protocol parameter details). Default values
can be entered for the following parameters:
— protocol type (Step/Ramp)
— basic load
— stage time
— load stage (load increase with each stage)
Use the softkeys on the right and left (
↑ ↓
) to position the
bar cursor on the protocol to change (No. 6 to 15) and
confirm the selection with
Select
.
Protocols
1. WHO
2. BAL
3. Hollmann
4. STD. France
5. Standard
Select
Figure 8 – 20: Selecting the exercise test protocol to configure
Use the softkeys (
↑ ↓
) to select the parameter to edit.
At
Select
, for example, you can choose the protocol type:
— Step (load increase in steps) or
— Ramp (continuous load increase).
Press
Select
to save the selected protocol type.
To cancel the selection, press the
key
.
Protocols 6.
Select
Step
Basic Load
25 W
Stage Time
2 min
Load Stage
25 W
Select
Figure 8 – 21: Selecting the parameter to edit
All other parameters are edited in the same way.
Using the arrow keys (
↑ ↓
), select a parameter and confirm
the selection with
Select
: the corresponding value is high-
lighted and can be changed with the arrow keys (
↑ ↓
).
Pressing
Select
will save the new value.
You exit the configuration with
.
Protocols 6.
Select
Step
Basic Load
25 W
Stage Time
2 min
Load Stage
25 W
Select
Figure 8 – 22: Editing the parameter value
Contrast
The display contrast is adjustable in the range from
0 to 100 %.
Contrast
Select
50 %
Figure 8 – 23: Adjusting the display contrast
Summary of Contents for ergoselect 4
Page 1: ...ergoselect 4 5 Ergometer Operator s Manual 201000433000 Version 2021 06 01 Rev 04 English...
Page 2: ......
Page 95: ......
