9 Control Terminal T
66
ergoselect 4 / 5
"Only Ch Memory" Mode
This mode is almost identical with the "Only Chipcard"
mode (see above).
Additionally, training results can be temporarily stored in
the memory of the ergometer in this mode.
Practical workflow:
1) The physician/therapist creates a chip card using the
opticare software. The data on the card are the patient
demographics and a training protocol specifically con-
figured for this particular patient.
2) The patient inserts the chip card in the ergometer and
completes the training session. The training results are
directly written to the chip card.
3) The patient informs the physician/therapist of the
results. The patient hands the chip card over to the
physician/therapist at the latest when the card is full.
4) The physician/therapist analyzes the training results
and modifies the training protocol if necessary.
5) While the training results on the chip card are analyzed
by the physician/therapist, the patient can continue
with the training sessions. The training results are
stored in the memory of the ergometer.
6) As soon as a training result is saved in the memory of
the ergometer, the patient is logged in. This means that
the ergometer will not accept the chip card of another
patient.
7) After modifying the training protocol, if applicable, and
deleting the training results, the physician/therapist
hands the analyzed chip card back to the patient.
8) The patient inserts the chip card in the ergometer.
First of all, the training results stored in the memory
of the ergometer are saved to the chip card. Then the
training protocol modified by the physician/therapist is
imported.
9) The patient exercises with the new, modified training
protocol. The training results are directly written to the
chip card again.
10) This procedure from step 3 onwards can be repeated
indefinitely.
Summary of Contents for ergoselect 4
Page 1: ...ergoselect 4 5 Ergometer Operator s Manual 201000433000 Version 2021 06 01 Rev 04 English...
Page 2: ......
Page 95: ......
