9 Control Terminal T
ergoselect 4 / 5
69
The following communication modes are supported:
•
Analog with pulse
Remote start mode; before advancing to the next load
level, the ergometer generates a control pulse and
sends the corresponding data via the interface.
•
Analog / Digital
An analog voltage controls the load – blood pressure
measurements can be initiated with digital commands.
•
Digital
(default)
The communication with the ergometer is entirely
controlled with digital commands.
•
Analog IN-OUT
The entire communication (load control and BP mea-
surements) is controlled with analog signals. No digital
data will be sent.
Choose the appropriate communication mode and confirm
with the [ ] key.
Analog with pulse
Analog/Digital
Digital
Analog IN-OUT
ECG Type
Figure 9 – 61: Setup – ECG type
Load Change
With this function, you select the increments for load
changes.
+/– 1 Watt
+/– 5 Watt
+/– 10 Watt
+/– 25 Watt
Individually
Load Change
Figure 9 – 62: Setup – load change
Summary of Contents for ergoselect 4
Page 1: ...ergoselect 4 5 Ergometer Operator s Manual 201000433000 Version 2021 06 01 Rev 04 English...
Page 2: ......
Page 95: ......
