9 Control Terminal T
ergoselect 4 / 5
47
9.2 Operating Modes with Control Terminal T
Ergometers with control terminal T support the following
operating modes:
PC Mode
An external device (e.g., an ECG recorder, a PC-based ECG
system) controls the ergometer – no intervention at all is
required at the ergometer.
PC Mode
Figure 9 – 4: PC mode
Ergometry
The ergometer automatically completes the selected exer-
cise test – the available protocols (5 preconfigured, editable
protocols and 5 user-configurable protocols) are saved in
the ergometer (see section “Editing Settings” on page 50).
Ergometry
Figure 9 – 5: Ergometry mode
Training / Test
Ten user-configurable training/test protocols are available
(see chapter 9.2.3 “Training / Test” on page 53).
Training/Test
Figure 9 – 6: Training/Test mode
Manual
The ergometer is controlled manually, i.e., the user per-
forms all load changes via the display.
Manual
Figure 9 – 7: Manual mode
Setup
Used to configure the ergometer. The button disappears
within 2 minutes after the ergometer was switched on.
This interval can be modified in the Service menu.
Setup
Figure 9 – 8: Setup mode
Summary of Contents for ergoselect 4
Page 1: ...ergoselect 4 5 Ergometer Operator s Manual 201000433000 Version 2021 06 01 Rev 04 English...
Page 2: ......
Page 95: ......
