Control Panel Instructions
LED Display
．
"
�
"
adjust the desk upwa『ds
．
"
�
"
adjust the desk downwa『ds
．
｀｀
直__. "
first height position saved by use『
．
＇，含
＇
second height position saved by use『
．
";I"
thi『d height position saved by use『
．
＇，成
”
Save, save height position
．
“息
”
Long time s1ttmg 『emmd Dutton,
remind of long time sitting
• When first powered up after setting it up, the LED display will show " RS「". Press T and
hold until the desk goes down to it's lowest position and shows "75.0", meaning the
current desk height is 75cm. The unit has now been correctly set up.
•
Once set up, use .._ and T to adjust the desk. The display will show the height, with the
height range being 75cm - 123cm.
•
Save:
a) Press .._ or T to move the desk to your desired height, for example "80.0".
b)
Press "M", and the display will show "S-". Press "1" to save the height 80.0cm to
save position 1. The display will show "S-1".
c)
Repeat steps a and b, saving 100cm to save position 2, and 120cm to save position
3. The display will show "S-2" and "S-3" respectively.
d)
Press 1, 2 or 3 to adjust the desk to the saved heights.
•
Inactivity Reminder: The desk can remind you when you have been sitting inactive for a
long time and you should get up and stretch your legs/back.
a) Press "A" to turn the reminder on. The display will show "On".
b) After 2 seconds, the 45 minute countdown will start. The display will show "45"
and countdown. Once it displays "00" there will be 10 seconds of beeping.
c) Within 10 seconds of the alarm sounding, pressing any button will result in another
45 minute countdown. If no button is pressed, the alarm will go silent and then
trigger off again after another 5 minutes. If there is still no button pressed after
that, another 45 minute countdown will automatically begin.
d) Press and hold "A" for 3 seconds to turn the inactivity reminder off. The display
will show "Off".
6
