SAA179 COMPACT MONITOR ARM
Installation Instructions
E.
G.
Slide tilter pin into end of arm.
Adjust vertical tilt resistance on tilter
head.
I.
F.
G.
Increase resistance to rotation at
articulation points by tightening small
set screws.
DO NOT OVERTIGHTEN.
Increase resistance to vertical travel
slightly with two hidden set screws on
bottom ends of lifting arm. This control
has modest effect and is set only after
gas cylinder floats LCD weight lessly.
1
2
3
4
5
6
7
8
9
Insert arm pin into completely attached
and assembled mount.
Put arm in horizontal position and
rotate wrench CLOCKWISE to WEAKEN
arm until monitor stays wherever it is
placed. See page 2 for more detailed
instructions.
C.
C.
C.
C.
A.
B.
D.
D.
D.
D.
Attach tilter head/VESA plate to
Monitor.
* Some monitors may require a spacer
hardware kit. See page 3 for details.
H.
H.
www.ergomart.com | 888 420 3200
Please call Ergomart at
888 420 3200
with your questions
www.ergomart.com
Ergonomic solutions for office and light industrial work environments
©2016 Ergomart. All rights reserved.
PAGE 1 OF 3
