Operation Manual
er900 PC Operation Manual
8
Version: 12/01
Art-Nr: 475.156
Ergometer
Type
er900 PC
It is necessary to ensure that no dangerous ground currents occur as a
result of attaching the ergometer to other devices. Device specifications
of the ergometrics er900 are in the appendix to this manual. Direct your
questions to your dealer or
to ergoline
’s service department. Especially
at the coupling of several devices to a measurement system is has to
be taken care, that proper grounding is achieved via a single power
supply, e.g. wall socket.
The ergometrics er900 ergometer should only be operated where elec-
trical requirements meet IEC 601-1.
This device is not suitable for use in rooms or areas where there is dan-
ger of explosion. .
Always observe accident prevention precautions when operating this
device.
In the event that the pressure in the blood pressure cuff is too high,
remove the cuff from the patient's arm immediately.
"
This unit may only be operated for therapy or diagnosis purposes under
the supervision of qualified personal.
2.4
Normative Notices
2.4.1
Notice for EMC (electromagnetic compatibility)
- The EMC test was done with a interference level of 3V/m. The device should not be
used in areas with a higher level.
- The device should not be used beside a high voltage system.
- To connect the device with other devices it's only allowed to use special shielded
cable provided by ergoline.
- Strong transmitting equipment may not be operated in the immediate vicinity of this
device..
- Electromagnetic interferences will appear first by a instable value of load in the dis-
play. If the value will change without reason while the speed is >30 1/min. It may be
that this is caused by an electromagnetic interference.
2.5
Requirements for Operating Personnel
The operating personnel of this ergometer have to be :
- properly instructed and trained regarding the operation of the ergometer,
- have to have full command regarding the handling of the device,
- have to aware of the applicable relevant safety requirements for the operation of
such devices, and act accordingly (see Chap. „
Introduction
“),
- have to be informed regarding additional regulations, e.g. safety regulations,
- have to be informed regarding potential hazard and risk arising from the operation of
such devices.
Safety Notices
