PL217 KEYBOARD PLATFORM
PLEASE REVIEW
these instructions before beginning the installation. Check that
all parts needed were provided with your order. Contact your supplier if any
operates to your satisfaction.
PARTS PROVIDED
Keyboard Platform and Mouse Platform (1 each)
Palm Rest (1)
Flathead Screw (4)
Flange Nut (4)
Cord Clips (2)
Panhead Screw (2)
#8-32x
1
/
2
#8x32
#8-32x
5
/
8
CAUTION:
Hand-tighten screws only. Do
not
use power tools.
ADDITIONAL TOOLS REQUIRED
• Phillips screwdriver
STEP 1: Attach Palm Rest
• Attach the palm rest to the keyboard platform.
Use two #8-32x
5
/
8
panhead screws and a
Phillips screwdriver. (Skip this step with Model
PL217NAT, which does not use a palm rest.)
STEP 2: Attach Mouse Platform
The mouse platform may be attached to either the left or
right side of the keyboard platform.
• The underside of the keyboard platform has brackets
on both the left and right sides. Loosen the
knob on the appropriate bracket.
• Slide the arm of the mouse platform
arm into the bracket and tighten
the knob.
Panhead
Screw
Mouse
Platform
