Uninstall Control Box Tray (6) and Control Box (5)
Note: Control box may have been
installed in alternative way and must
be unscrewed instead of uninserted.
Remove
Take control box (5) off of
control box tray (6)
Disconnect all cables (7,9,10) from Control Box (5)
Unscrew Tabletop (2) from Support Plates (8)
Uninstall Feet (4)
Detach Feet (4) from Support Legs (3) using a 5*5 Allen Key (E)
to loosen the eight bolts (C).
Uninstall Support Legs (3)
Detach Support Legs (3) from Crossbar (1) using a 4*4 Allen Key
(E) to loosen the eight bolts (B).
Remove
Before uninstalling the support
legs, rotate plates as shown.
Rotate counterclockwise
from dotted line
Rotate clockwise from
dotted line
Uninstall Side Supports (2)
Detach Side Supports (2) from Crossbar (1) using a 4*4 Allen Key
(E) to loosen the four bolts (D).
NOTE: Ergonomic Tabletop model has
only 2 bolts, with a shorter support plate
with 2 bolt holes.
Note: Crossbeam length dependent
upon how installation was performed
following instructions on right.
