5
Clamp Mount
3) Position the lift assembly with the
back edge of the lift assembly flush with
the back edge of the desk. Position
Clamps over slots in base plate, making
sure the threaded portion of the button
head screw engages the slot as shown in
the inset image on the right. If there is a
vertical wall directly behind desk, a 3/8”
gap is required to install clamp. If this is
the case, the lower bracket will need to be removed from the upper bracket.
4) If there is not a large enough gap
between the rear edge of the desk and
the wall or obstruction, the clamp must
be disassembled to position in place.
Remove button head screws holding the
upper and lower clamp brackets
together.
5) Slide the upper clamp bracket behind
desk.
