3. Proper use
The hot air gun is designed for heating shrink-down
plastic tubing, for stripping paints and for welding and
shaping plastics.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage:
230 V ~ 50 Hz
Power input:
2000 W
Temperature:
70°C / Setting 1
380°C / Setting 2
600°C / Setting 3
Air volume:
550 l / Setting 1
350 l / Setting 2
550 l / Setting 3
Protection class:
II /
쓑
Weight:
0.8 kg
5. Before starting the equipment
앬
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
6. Starting up
6.1 3-setting ON/OFF switch (Figure 1)
Select the required operating temperature and air
volume with the ON/OFF switch (2).
Within a very short space of time the hot air gun
will reach operating temperature.
Switch position 0:
Equipment is switched off.
Switch position 1:
Setting 1 – 70°C / 550 liters/min.
Switch position 2:
Setting 2 – 380°C / 350 liters/min.
Switch position 3:
Setting 3 – 600°C / 550 liters/min.
6.2 Possible uses for the hot air pistol:
앬
Removal of paint and lacquer.
Attention!
Hazardous or poisonous gasses may be
produced while removing paint or lacquer. Be
sure to provide adequate ventilation.
앬
Removal of stickers and decorations.
앬
Loosening of rusted or tightly fastened nuts and
metal screws.
앬
Thawing of frozen pipes, door locks, etc.
Attention: no not attempt to thaw plastic or
synthetic pipes.
앬
Accentuation of natural wood grains before
staining or lacqueing.
앬
Shrinkage of PVC packaging foils and insulation
tubes.
앬
Waxing and de-waxing of skis.
Caution: Intensive heating means a higher risk of
fire and explosion! Ensure good ventilation.
Harmful and/or toxic gases and vapors may be
emitted.
6.3 Choosing the right nozzle:
앬
The deflector nozzle (4) diverts the hot air to
protect glass etc. from overheating. Use it to strip
paints.
앬
Use the fishtail nozzle (5) to distribute the air
uniformly over small areas.
앬
Use the cone nozzle (6) to confine the heat to
corners and small areas.
앬
Use the reflector nozzle (7) to solder and shape
pipes, to thaw frozen water pipes and to heat
shrink-down insulation tubing.
7. Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
9
GB
Anleitung_E_HP_2000_SPK7:_ 10.12.2009 13:04 Uhr Seite 9
