888-SV-22DL-00 rev C
5
Riser Lift Adjustment
Cable Routing.
8
Cable Routing
20"
(508 mm)
c
Connect one end of the RUI
cables to the RUI that is mounted
to the riser. Connect grey cable to
grey jack and black cable to black
jack.
d
Remove side covers of cable
box mounted under the drawer.
Route the RUI and computer
cables down riser and into the
cable box. Route keyboard and
mouse cables into the cable box.
Use cable box to store excess
cable and power bricks.
e
Route cables out of cable box,
through cable channel to CPU.
Bundle the length of cables from
cable box to cable channel inside
one 20" (508 mm) length of the
provided fl exible tubing.
*
Leave about 20" (508 mm) of slack in
cables between the cable box and the cable channel.
f
Wrap any equipment cables and cords that need
to connect to the CPU at the rear of the cart inside a
second length of the provided fl exible tubing.
g
Route the RUI cables along with the equipment
power cords, down the channel to the outlets
under the front cover. Connect the RUI cables and
plug-in the power cords.
CAUTION:
Route cables on Cable Channel
(right) side of Cart only. Do not store power brick
inside base covers. Storing power brick inside base
covers may damage electrical wires and interfere
with riser operation, resulting in damage to both
Cart and mounted equipment or injury from elec-
trical shock.
h
Close cable channel around wrapped cables
and replace cable box side covers. Move riser up
and down to ensure cables are routed properly and
movement of the riser is not restricted. Adjust if
necessary.
c
d
e
*
h
f
g
CAUTION:
Observe maximum watt ratings, do
not connect equipment that will draw beyond the 300
watt capacity of the power system in your StyleView
Cart. Failure to comply with this safety hazard may
result in equipment damage.
a
Unlock riser (lift brake up).
b
Move the riser up and down.
If you feel excessive resistance
within the range of motion, or
if the riser does not stay in the
desired position, the lift tension
should be adjusted.
c
Remove tower cover.
9
Set riser lift tension.
b
a
c
h
8-32 x 1/4"
2x
g
Summary of Contents for StyleView SV22-92023
Page 14: ...888 SV 22DL 00 rev C 14...
