888-SV-22DL-00 rev C
8
8
10mm
m
Remove boot to expose Red (+) connector. Connect Red (+) lead to battery with terminal bolt and
wrench.
Connect Red lead BEFORE Black lead!
Be careful not to contact tools between terminals on
battery and metal chassis. Place boot on Red terminal.
n
Remove boot to expose Black (-) connector. Connect Black (-) lead to battery with terminal bolt and
wrench.
Connect Black lead AFTER Red lead!
Be careful not to contact tools between terminals on
battery and metal chassis. Place boot on Black terminal.
Red
Red
Black
Black
o
Plug-in cord reel cable.
p
Attach cover to cart and tighten screws.
10mm
1/8"
l
k
n
m
p
o
BATTERY
LEAD
Battery Replacement
- SHORT TERM
*
If the Power System will be idle for up
to three months, the battery should be fully
charged before storage and recharged during
storage.
If the Power System will be idle for 3 months
or more, the battery should be removed from
the cart and stored, follow LONG TERM Storage
instructions!
a
Turn off all mounted equipment.
b
Plug power cord into appropriate wall
outlet to fully charge battery to 100% (all RUI
indicator lights will be illuminated).
Power
system must be fully charged before storing!
c
Once battery has been charged to 100%,
turn power system off by holding down the
AC Outlet Power
on the RUI for 1 - 3
seconds. Power light will shut off .
d
Leave power cord plugged into appro-
priate wall outlet if possible. If wall outlet is
not available for cart storage, remove front
cover, disconnect RUI cables from jacks
located on side of outlet box, and replace
cover. If cart is not plugged into a wall outlet
while stored, recharge battery once a month.
NOTICE:
Warranty on fully charged bat-
teries left in an unused state for more than three
(3) consecutive months is automatically void.
Warranty on fully discharged batteries left in an
unused state for more than three (3) consecutive
days is automatically void.
a
c
Power System Storage
b
Power System Storage
*
Follow LONG TERM Storage Steps (a) - (i) to remove existing battery then continue
with steps (k) - (p) below, to connect the replacement battery.
k
After removing battery from cart, lift out of tray. Recycle battery or contact Ergotron for proper
battery disposal guidelines.
l
Place new battery in tray; insert battery into cart.
Replacing Battery
WARNING: Only Ergotron-specifi ed batteries may be used in the StyleView Power System.
Please call customer care for details.
Do not replace the batteries while cart is located in an oxygen rich or hazardous environment.
Sparking may occur.
2
Summary of Contents for StyleView SV22-92023
Page 14: ...888 SV 22DL 00 rev C 14...
