6/12
888-24-090-G-00 rev. D • 11/10
6
EN
Set-up
USB Type A
connection on
computer
Ethernet Crossover
connection on
computer
NOTE
: these cables are
factory-connected to
the USB Hub.
4.
Depress and hold Ready On button for 15 seconds.
5.
Turn Computer off .
6.
Install the worksurface and press Ready On Button. Do not hold button down, only press for a second and then wait for computer to turn on. Computer should turn on.
If it does not turn on repeat steps 1 - 6. If computer still does not turn on, contact Ergotron Customer Care.
WARNING:
Fan must always be running when computer is on. Operating computer without fan may
lead to overheating, resulting in reduced equipment performance.
3. Plug the following factory connected cables into your computer.
Ethernet Crossover:
This cable runs from the cart's Ready On Ethernet Port to your computer and is used for the Ready On feature.
USB:
This cable runs from the USB Hub to your computer and uses your computer to power the USB Hub and Keyboard Lights. (NOTE: Your computer must be turned on for
the USB Hub and Keyboard Lights to function).
Fan:
This cable runs from the fan to your computer so the fan will run when your computer is on.
Keyboard Light
Keyboard Light will automatically turn off after 15 minutes if not
manually turned off .
Do Not connect or use fan with USFF (Ultra Small Form Factor) CPU's.
