10
11
The wave with the corresponding
spectrum of harmonics will appear
on the screen. You also can alter
the wave by adjusting harmonics.
Use the left encoder to navigate thru
harmonics (selected one gets bolder)
and the right one to adjust amplitude
of the harmonic.
You also can design the wave only by adding harmonics in various
amplitudes. Just select the new wave and start with the SPECTRAL icon.
Each harmonic represents a sinewave with a frequency which is multiple
of the first harmonic. Use the left encoder to navigate thru harmonics
(selected one gets bolder) and the right one to adjust amplitude of the
harmonic.
If you are not happy with the wave
created, just click the
X BOX
and the
wave will be erased and you can start
drawing the new wave from scratch.
Once you are happy with the wave,
you’ve created, select SAVE box and
save the wave. NAME menu will
appear.
In the NAME menu you can name your
waveform and save in user generated
wavetables. Follow the pop-up
screens to allocate the wave in a
desired wavetable. You can change
the position of the wave in the list in
the MANAGE menu.
As you draw the wave, you can check
the
HARMONIC CONTENT
of it,
specifically, the first 32 harmonics. To
do so, use the left encoder to select
SPECTRAL icon in the top row.
You can’t move the cursor left, as the
wave should change over the time,
and it can’t go back in the past. We
recommend to draw waves that start
and end at horizontal axis otherwise
you may hear undesired clicks.
In
LINE SKETCH
mode you can
draw the wave by connecting lines
between two points defined by
cursor. move the cursor to desired
position and push the left encoder to
initiate drawing.
In the
PEN SKETCH
mode you just
use both encoders to draw the wave
form scratch. The left encoder moves
drawing cursor up and down, the
right – right. Push the right encoder to
initiate drawing. The cursor will change
to small cross.
Summary of Contents for GraphicVco
Page 1: ...USER MANUAL...
