PAINT BORER 518 USB
25
BAE 518 USB
5.3.2 Selecting the circles
(Always start with circle 1.)
Circle 1
is always the inner substrate circle.
Circle 2
is, in this case, the primer.
Circle 3
is, in this case, the top coat.
5.3.3 Tracing the circles
Select the Circle 1 (which is now dark) and move the cursor to the edge of the substrate
borehole. Press and hold the left mouse button in this position. Press down on the
mouse button as you draw the circle and align it accurately; then release the mouse
button.
Select the Circle 2. Draw a circle on the outer edge of the primer and position it.
Click on the Circle 3. Draw a circle on the outer edge of the top coat and position it.
Click with the
right
button to finish after the last circle. All circles and circle buttons
should now be red.
If the positioning is not successful, then select the circle button corresponding to the
"unsuccessful" circle button again. Then delete the circle (
) or draw and position
a new circle. This process is almost always successful after a little practice.
Click on
to delete all circles simultaneously.
