PAINT BORER 518 USB
15
BAE 518 USB
Briefly press the button to turn on the LED. The mid-level brightness will be set
automatically after the LED is turned on.
The three levels of brightness can be switched on consecutively by repeatedly pressing
the button.
Press and hold the button to turn the LED off. The LED will also turn off automatically
after 60 seconds.
Example:
Grey plastic coating
without additional lighting
with additional lighting
White top coating
without additional lighting
with additional lighting
Colored coatings or multi-colored coating systems provide a higher contrast so that side
lighting is not necessary.
3.3 Setting the image focus
The image focus is pre-set.
If you still need to adjust the focus, the adjusting dial can be turned slightly to the left or
right to make adjustments.
! You will then need to carry out a calibration!