EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
©
Ericsson AB 2010
Commercial in confidence
102 (200)
c.
Now wait and be patient whilst the fields in the above table are slowly filled
in. When the “Stored Entries” are shown in black all entries have been
read, refer to the following example screen.
d.
Scroll down the table and check that all card slot entries are displayed in
the “User Port” column.
e.
In the “
Ne Name”
column check that the OOB IP address is correct for the
Node being commissioned. The Out Of Band IP Address is determined by
the DLE ID, refer to Section 5.5. Change the address (if necessary) in this
column for all entries, as follows:-
Change the 1
st
entry in this column to the correct IP address, select the 1
st
entry, then left-click the 1
st
entry & drag down to the bottom of the column
to highlight all entries. Right click & select “
Replicate cell
”, all entries in the
“
Ne Name”
column will now be set to the required OOB IP Address.
f.
In the “
ATM Traffic Separator Only
” column, change the entries from
“false” to “
true
”, as follows:-
Double click on the 1
st
entry in this column and from the drop-down list
select the “
true
” option, select the 1
st
entry, then left-click & drag down to
the bottom of the column to highlight all entries. Right click & select
“
Replicate cell
”, all entries in the “ATM Traffic Separator Only
”
column
should now be set to “
true
”. Check that all entries have been changed
correctly.
