EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
©
Ericsson AB 2010
Commercial in confidence
155 (200)
g.
Wait until the Address: shows Slot (as selected), Card Type: ADSLx64,
Line: (as selected) then check the Configuration Profile is set to
ADSL2plus_SLOW_BASIC
and that only the three Transmission Mode
Type boxes (as shown in step e) are ticked.
h.
Repeat steps (f.) to (g.) for all 64 lines on the 64 x ADSL card.
Note:
If you find more than 5 incorrectly configured lines on one card, stop
checking and refer to Section 9.1.2 ‘Configure 64 x ADSL Card for ADSL2+
Configuration Profile’.
i.
When all 64 lines have been checked on the 64 x ADSL card click on the
Close
button to close the window.
j.
Repeat the checks (steps a to i) for each new 64 x ADSL Card.
k.
If any incorrectly configured ADSL lines were found, they must be re-
configured as described in Section 9.1.2 ‘Configure 64 x ADSL Card for
ADSL 2 + Profile’.
9.1.2
Configure 64 x ADSL Card for ADSL2 + Configuration Profile
This Section is only required if some ADSL lines are incorrectly configured.
9.1.2.1
Disable all 64 ADSL Lines on the 64 x ADSL Card
The ADSL Lines must be disabled before their profile can be changed.
a.
From the LCT main screen select the path;-
Configuration
→
xDSL Line Activation
b. Set
the
Slot:
box to the ADSL card slot to be re-configured.
c. Select
the
~
Disable
radio button.
d.
Click on the
GO
button. Wait for all 64 lines to be disabled.
