EDA 2530 Commissioning Procedure for Cable and Wireless Access
1/153 22-FGC 101 0239/2 Uen Rev J 2010-04-01
©
Ericsson AB 2010
Commercial in confidence
47 (200)
5
Initial Configuration
Prior to testing, the Common Part IP unit requires configuring in accordance with the
parameters assigned to the system.
This section details the process to configure IP addresses/parameters needed for
management of the equipment from LCT and from the appropriate workstation for
network management.
For identification of the IP addresses/parameters assigned to the system, refer to
the Network planning guide.
5.1
IP Address Configuration Of PC Used As LCT
Before connecting the laptop to the Common Part IP unit, the laptop must be
configured to be in the same IP Network Address range as the Out of Band
Management IP Address of the EDA 2530.
Note:
For Windows 2000 OS use step a, for Windows XP use step b, and for
Vista OS use step c, all other steps are common to Windows 2000/XP/Vista OS.
a.
For Windows 2000
, left click on the
Start
button, then select
Settings >
Control Panel
.
Double left click on the
Network and Dial-up Connections
icon.
b.
For Windows XP
, left click on the
Start
button, then select
Control Panel
.
Double left click on the
Network Connections
icon.
c.
For Windows Vista
, left click on the
Start
button, then select
Network
>
Network and Sharing Center
>
Manage network connections.
d.
Right click on
Local Area Connection
icon and then click
Properties
.
e.
In the ‘LAN Properties’ window, use the scrollbar to move down the list.
f.
For Windows 2000/XP select the ‘
Internet Protocol (TCP/IP)
entry, but for
Windows Vista select the ‘
Internet Protocol Version 4 (TCP/IPv4)
option,
then left click on the ‘
Properties
’ button.
