Firewall CLI Commands
234
2/1553-ZAT 759 94 Uen B – December 2005
10.10
firewall list portfilters
10.10.1 Syntax
firewall list portfilters <policyname>
10.10.2 Description
This command lists portfilters that were added to a firewall policy using the
firewall add portfilter command. It displays the following information:
•
Portfilter ID number.
•
Portfilter
name.
•
Type – port number range or specified port number.
•
Port range used by the specified TCP or UDP protocol (e.g., 53 for DNS,
25 for SMTP). For non-TCP/UDP protocols, the port range is set to 0-0.
•
In – displays the inbound permission setting (true or false).
•
Out – displays the outbound permission setting (true or false).
•
Raw – displays whether or not the portfilter uses a non-TCP/UDP protocol
(true or false).
•
TCP – displays whether or not the portfilter uses a TCP protocol (true or
false).
•
UDP – displays whether or not the portfilter uses a UDP protocol (true or
false).
10.10.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
policyname
A name that identifies a firewall policy.
To display policy names, use the
firewall list policies
command.
N/A
10.10.4 Example
-->
firewall list portfilters ext-dmz