PPPoA CLI Commands
394
2/1553-ZAT 759 94 Uen B – December 2005
16.10
pppoa set transport dialin pvc
16.10.1 Syntax
pppoa set transport {<name>|<number>} dialin pvc <port>
<vpi> <vci>
16.10.2 Description
This command sets an existing PPPoA transport to accept dialin connections
over a PVC (Permanent Virtual Circuit). This replaces the transports existing
dialin/dialout setting over PVC/SVC. The PVC uses the interface that was
specified when the transport was created.
The command allows you to specify the following information:
•
The ATM port that will transport data.
•
VPI (Virtual Path Identifier).
•
VCI (Virtual Circuit Identifier).
The port/VPI/VCI combination must be unique for each transport.
16.10.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
PPPoA transport. To display transport
names, use the
pppoa list
transports
command.
N/A
number
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the
pppoa list
transports
command.
N/A
port
The system port that is used to
transport ATM data.
N/A