PPPoA CLI Commands
2/1553-ZAT 759 94 Uen B – December 2005
409
16.22
pppoa set transport ipv6cp
16.22.1 Syntax
pppoa set transport {<name>|<number>} ipv6cp
{enabled|disabled}
16.22.2 Description
This command enables/disables IPv6 & Control Protocol (IPv6CP) on the
specified PPP transport. IPv6CP is responsible for configuring, enabling and
disabling the IPv6 protocol modules on both ends of the point-to-point link.
16.22.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
PPPoA transport. To display transport
names, use the
pppoa list
transports
command.
N/A
number
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the
pppoa list
transports
command.
N/A
enabled
Enables IPv6CP on the specified
transport.
disabled
Disables IPv6CP on the specified
transport.
disabled
16.22.4 Example
-->
pppoa set transport pppoa1 ipv6cp enabled