PPPoA CLI Commands
2/1553-ZAT 759 94 Uen B – December 2005
413
16.26
pppoa set transport lcpmaxterm
16.26.1 Syntax
pppoa set transport {<name>|<number>} lcpmaxterm <lcp max
terminate>
16.26.2 Description
This command sets the Link Control Protocol (LCP) maximum terminate
number for an existing PPPoA transport.
16.26.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
PPPoA transport. To display transport
names, use the
pppoa list
transports
command.
N/A
number
A number that identifies an existing
PPPoA transport. To display transport
numbers, use the
pppoa list
transports
command.
N/A
lcp max
term
Link Control Protocol; the maximum
number of consecutive Terminate
Requests that will be sent without
reply before assuming that the
destination address is unable to
respond. The LCPmaxterm can be any
positive value.
2
16.26.4 Example
-->
pppoa set transport pppoa1 lcpmaxterm 20