PPPoE CLI Commands
2/1553-ZAT 759 94 Uen B – December 2005
463
17.11
pppoe set transport createroute
17.11.1 Syntax
pppoe set transport {<name>|<number>} createroute
{enabled|disabled}
17.11.2 Description
This command specifies whether a route is added to the system after IPCP
(Internet Protocol Control Protocol) negotiation is completed. If set to
enabled
,
a route will be created which directs packets to the remote and of the PPP
link.
This route can either be a default route or a specific route, depending on the
value set using the
pppoe set transport specificroute
command.
To display the createroute settings, use the
pppoe show transport
command. The route is removed when the PPP link is disconnected.
17.11.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
PPPoE transport. To display transport
names, use the
pppoe list
transports
command.
N/A
number
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the
pppoe list
transports
command.
N/A
enabled
Adds a route to the system after IPCP
negotiation.
disabled
Does not add a route to the system
after IPCP negotiation.
enabled
17.11.4 Example
-->
pppoe set transport pppoe1 createroute disabled