PPPoE CLI Commands
2/1553-ZAT 759 94 Uen B – December 2005
465
17.13
pppoe set transport discoverdns primary
17.13.1 Syntax
pppoe set transport {<name>|<number>} discoverdns primary
{enabled|disabled}
17.13.2 Description
Note:
You must enable one of the
pppoe set transport givedns
commands in order for this command setting to work.
This command enables/disables whether the primary DNS server address is
requested from a remote PPP peer using IPCP. The default setting for this
command is
enabled
. The default setting for the
pppoe set transport
givedns
commands is also
enabled
.
17.13.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
PPPoE transport. To display transport
names, use the
pppoe list
transports
command.
N/A
number
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the
pppoe list
transports
command.
N/A
enabled
A primary DNS server IP address is
requested.
disabled
A primary DNS server IP address is
not requested.
enabled
17.13.4 Example
-->
pppoe set transport pppoe3 discoverdns primary
enabled