PPPoE CLI Commands
468
2/1553-ZAT 759 94 Uen B – December 2005
17.16
pppoe set transport enabled|disabled
17.16.1 Syntax
pppoe set transport {<name>|<number>} {enabled|disabled}
17.16.2 Description
This command explicitly enables/disables a PPPoE transport. Attaching a
transport to an interface implicitly enables it, but for cases where no attach is
performed (for example, multiple channels on an interface, a PPP session that
is not attached but needed for testing purposes) the transport must be enabled
explicitly.
17.16.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
PPPoE transport. To display transport
names, use the
pppoe list
transports
command.
N/A
number
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the
pppoe list
transports
command.
N/A
enabled
Enables a PPPoE transport.
disabled
Disables a PPPoE transport.
disabled
17.16.4 Example
-->
pppoe set transport pppoe1 enabled