PPPoE CLI Commands
472
2/1553-ZAT 759 94 Uen B – December 2005
17.19
pppoe set transport givedns relay enabled|disabled
17.19.1 Syntax
pppoe set transport {<name>|<number>} givedns relay
{enabled|disabled}
17.19.2 Description
This command controls whether the PPP Internet Protocol Control Protocol
(IPCP) can request the DNS server IP address for a remote PPP peer. Once
IPCP has discovered the DNS server IP address, It automatically gives the
address to the local DNS relay so that a connection can be established.
17.19.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
PPPoE transport. To display transport
names, use the
pppoe list
transports
command.
N/A
number
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the
pppoe list
transports
command.
N/A
enabled
IPCP can request a DNS server IP
address and then give the address to
DNS relay.
disabled
IPCP cannot request a DNS server IP
address and then give the address to
DNS relay.
enabled
17.19.4 Example
-->
pppoe set transport pppoe1 givedns relay enabled