PPPoE CLI Commands
476
2/1553-ZAT 759 94 Uen B – December 2005
17.23
pppoe set transport ipv6cp
17.23.1 Syntax
pppoe set transport {<name>|<number>} ipv6cp
{enabled|disabled}
17.23.2 Description
This command enables/disables Ipv6 & Control Protocol (IPv6CP) on the
specified PPP transport. IPv6CP is responsible for configuring, enabling and
disabling the IPv6 protocol modules on both ends of the point-to-point link.
17.23.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
PPPoE transport. To display transport
names, use the
pppoe list
transports
command.
N/A
number
A number that identifies an existing
PPPoE transport. To display transport
numbers, use the
pppoe list
transports
command.
N/A
enabled
Enables IPv6CP on the specified
transport.
disabled
Disables IPv6CP on the specified
transport.
disabled
17.23.4 Example
-->
pppoe set transport pppoe1 ipv6cp enabled