SNMP CLI Commands
2/1553-ZAT 759 94 Uen B – December 2005
611
20.4
snmp set communityname
20.4.1 Syntax
snmp set communityname <name> [[access <read|write>]
[community <community>] [manager <ipaddress>]
[permanently <enabled|disabled>] [temporarily
<enabled|disabled>]]
20.4.2 Description
This command allows you to change settings to a community name previously
added to the system using the
snmp add communityname
command.
20.4.3 Options
The following table gives the range of values for each option which can be
specified with this command and a default value (if applicable).
Option Description
Default
value
name
A name that identifies an existing
community name. To display
community names, use the
snmp
list communitynames
command.
N/A
community
The community name of an existing
community. To display community
names, use the
snmp list
communitynames
command.
N/A
manager
The IP address of the manager from
which requests are restricted by.
N/A
permanently
Enabled
temporarily
Enabled
20.4.4 Example
-->
snmp set communityname tonyget access write