Installing and Powering Up
2.8.1.4
Output Mode
Table 2.6 Output Mode Configurations
Output Mode Description
Port 1 Port 2 Port 3 Port 4
1 Independent Either one or both output ports can be
configured as an output.
No switching is done between the output
ports. If two outputs are employed then
they are totally independent of each other.
Input Input Output
Output
2 Autonomous
Both outputs are used but only one at a
time.
Redundancy switching is done between
the two outputs.
Input Input Output
Output
3 Mirrored
Both outputs are used at the same time.
The same data appears on both the output
ports.
Input Input Output
Output
2.8.2
Static Parameters
2.8.2.1
Data Ports
When this entry in the Static Parameters is selected (See
Annex C
for a typical full
display), it displays a table listing the physical port numbers associated with the
modules installed in the unit. A typical example is shown in
entries are described in
Notes:
The sequence of numbering of the ports and IP address depends on the
physical location on the card in the unit.
Actual IP Addresses etc depend on the network setting.
Figure 2.7 Static Parameters - Editing Data Ports
2/1553-FGC 101 1014 Uen B
2-19
Summary of Contents for MX8400
