Eriez FJ-310A, Installation, Operation And Maintenance Instructions

18

C.  Turn the unit on by placing the on-off-on  
 

switch to the “DISCHARGE ON” position. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
D.  Depress the handle of the discharge nozzle  
 

to begin the fluid flow. 

E.  When discharging operation is complete,  
 

turn the unit off.  

F.  The Sump Cleaner will discharge nearly all the  
 

fluid in the bottom of the tank compartment.  

This is unimportant if the unit remains in  

reasonably frequent use on a single coolant.  

If different coolants are used, or the unit will be  

stored for some time, remove the discharge  

hose, hose fitting on the bottom of the unit,  

and drain the unit completely.

6.  To empty the Filter Basket: 

A.   Remove lid.  
B.   Attach an OSHA approved lifting device to the  
 

basket rings. 

CAuTION:

 All components used  

to lift the basket (steel cable, hooks, hoist,  

crane, etc.) must have a minimum capacity  

of 1,000 pounds or 455 kg. 

C.   To avoid the basket binding in the tower during  
 

removal, position the lifting power source (e.g.  

crane) directly over the center of the basket. 

D.   Hoist the basket. Keep hands and fingers  
 

clear. If the basket is not exiting the center of  

the tower, return (lower) the basket to chip  

tower. Reposition the lifting device so that  

the basket exits the center of the tower. 

E.  

DO NOT TOuCH BASKET DuRING  

 REMOVAl.

F.  Position the basket over the waste  
 receptacle. 
G.  For 50-gallon units, empty contents by  
 

inverting the basket using handles welded  

to the base of the basket. 

For 65-gallon units and larger, open the basket  

door by pulling the locking pin cable. 

H.   Once the basket is empty, carefully close the  
 

trap door and slide the locking pin into place. 

I.   Check the filter sleeve. If it is badly soiled or  
 

clogged, turn it inside out and wash it with a  

non-solvent cleaning solution. Replace the  

filter when necessary. 

J.   Inspect the basket hoisting rings for signs  
 

of rust. Replace the basket assembly with  

a new one if the rings are heavily corroded. 

K.   Keeping hands and fingers from under the  
 

basket lip, reseat the basket in the tank and  

fasten down the tank lid.

120V Dual Tank
Operation

1.  Before operating this equipment for the first time, 

and periodically thereafter, review the SAFETY 
INFORMATION beginning on page three of  
this manual.

2.  Suction vacuum and discharge pressure are 

simultaneously applied to both compartments  
of this twin compartment unit. Select the 
compartment to be used by attaching the hoses  
to the appropriate fittings and cap off the other 
tank fittings. 
 
                                                                  

Continued