24
1. Check the filter basket’s polypropylene mesh filter
sleeve frequently. If it is badly soiled or clogged,
remove the retaining ring beneath the lifting rings,
and take off the gasket over the basket’s top ring.
Lift out the sleeve, turn it inside out and wash it in
a suitable cleaner.
2. If the filter sleeve is torn, or if it is soiled or clogged
to the point where simple cleaning is inadequate,
replace the sleeve with a new one (part number
60-1460).
3. To install a new sleeve: with the basket gasket and
retaining ring removed, fit the sleeve inside the
basket. Fold the top edge out over the basket’s top
ring, and snug down the gasket to hold the sleeve
in place. Make two small holes in the sleeve over
the basket’s lifting rings. Pull the rings through. Fit
the retaining ring into the basket beneath the lifting
rings and tighten it out securely against the basket.
Maintenance
Lifting Ring
Retaining Ring
Top Gasket
4. Frequently check the basket lifting rings for signs
of rust. If the rings become badly corroded,
replace the basket with a new one.
5. If the filter sleeve is maintained in good condition,
only fine particles should settle out in the bottom
of the tank. Remove these periodically by opening
the drain plug and with the filter basket out of the
sump cleaner, flush the tank with a water hose.
6. Periodically, while the basket is out of the tank,
check the tank interior for sludge buildup. If such
a buildup starts to thicken, use an appropriate
tool to scrape it off the tank walls and out of
the cleanout door.
7. On 3-Phase electric and LP gas units, periodically
check the pump oil level and fill if required. (See
the manufacturer’s operating manual provided
with your cleaner.)
8. On 3-Phase electric and LP gas units, grease the
pump bearings at least every three months. For
type of lubricant, see the recommendations in the
manufacturer’s operating manual provided with
this equipment.
9. On LP units, periodically check the engine oil level
and fill if required. (See manufacturer’s operating
manual provided with your cleaner).
10. Periodically check hoses for deterioration and
replace with new ones if leaks have developed
or appear imminent. Always coil hoses properly
over the supports provided when not in use.
11. Other than the routine maintenance operations
specified above, adjustments and/or repairs to
this equipment should be undertaken only by
authorized service personnel. If these personnel
need more information than is provided in this
manual, they should contact Eriez HydroFlow
at 814-520-8540.
Summary of Contents for FJ-310A
Page 27: ...Sump Cleaner 27...
