Eriez FJ-310A, Installation, Operation And Maintenance Instructions

6

Sump Cleaner Warranty 

(cont.)

Eriez HydroFlow shall not be liable for any damage  
to or loss of any cutting fluids or for loss of any income 
or profits due to the malfunctioning of the equipment 
hereinafter described, whether the malfunctioning is 
caused by defects in factory workmanship and/or  
faulty material, or any other cause whatsoever.
Component parts returned for replacement must 
show the original unit serial number from which 
they were removed. Parts returned without the 
aforementioned serial number will be replaced at 
established replacement prices. This warranty does 
not cover equipment damaged by misuse, negligence 
or accident. Vacuum and pressure relief valves are 
preset at the factory. ALTERATION OF THE SETTING 
EXCEPT WITH THE SPECIFIC AUTHORIZATION 
OF ERIEZ HydroFlow OR ITS AUTHORIZED 
REPRESENTATIVES WILL VOID THIS WARRANTY.

1.  Remove the cover of the basket. Keep hands and 

fingers from under the filter basket gasket. Take 
out the following items:

A.  Filter basket (factory assembled with sleeve)

B.  Discharge hose with nozzle

C.  Suction hose

D.  Cleaning tool

E.  Spare filter sleeve or filter bags

F.  LP bottle brackets (on LP models)

2.  Check the locking pin that holds the filter basket’s 

trapdoor shut. Make sure it is securely in place 
(fully extended as shown in the drawing at the  
end of the manual).

3.  Keeping hands and fingers from under the basket 

lip, reseat the filter basket in the tank. Replace the 
tank lid and clamp it down.

4.  Attach the suction hose to the intake connection 

on the tank lid. Attach the cleaning tool to this 
hose, then coil the hose around the push handle 
or hose hangers provided at the basket end of the 
tank. Place cleaning tool in pipe holder attached  
to the side of the tank.

5.  Couple the discharge hose to the discharge 

connection on the side of the tank and coil it over 
the push handle or hose hangers provided. Make 
sure the discharge nozzle assembly is installed  
on the other end of the hose.

6.  On LP models, remove the bolts from the side  

of the base plate and mount the bottle brackets  
on the plate using the bolts provided.

Assembly