Troubleshooting
Rev: 0-3 (international, serial no. 3010)
- 6-3 -
May 2006
PROBLEM
CAUSE
SOLUTION
High engine temperature.
System needs time to cool down before
restarting. (Engine temperature shut-
down is 96
°
C [205°F] ).
Clean radiator and cooler of any dirt.
Inspect for any malfunction.
Fuel pump fuse is burnt.
Check fuse (15A) on relay K2. Replace
if necessary.
Control fuse is burnt.
Check fuse (15A) on relay K1. Replace
if necessary.
Engine stops
during production.
Engine problem.
Refer to your engine operation guide or
contact your nearest Caterpillar dealer.
Engine is not running.
Review starting procedure.
Activating levers not charged
with hydraulic oil.
Push down the lever H on Power Pack
before activating levers.
Fine, Reject and
Middle Stackers, and
Screen Box will not
move.
Hydraulic leakage or ruptured
hose.
Tighten the fittings or replace the
hydraulic hose.
Engine is not running.
Review starting procedure.
The hydraulic flow control is
closed.
Turn the flow control next to the
controls at the rear of the machine.
Hydraulic lever off.
Activate the lever.
Blockage on one of the
conveyors.
Check all the conveyors. Clean if
necessary.
Belt slipping.
Tighten belt (see
Section
4.5
for
instructions).
Hydraulic leakage or ruptured
hose.
Tighten the fittings or replace the
hydraulic hose.
Belt on conveyors
will not run.
Pillow block bearings are
defective.
Replace them.
Summary of Contents for Fingerscreener 206T
