Safety
Rev: 0-3 (international, serial no. 3010)
- 1-2 -
May 2006
overalls, helmet, visor, gloves and steel-cap boots must be worn at all times when working
close to a hydraulic unit.
1.1.2 Labelling of Controls and Warning Notices
Emergency-stop devices and other equipment controls are labelled with permanent fixed
stickers, as are certain warning notices and instructions for safe and effective operations.
These stickers must remain in place and legible at all times.
Every worker who operates equipment must know the location and operation of all controls
and must understand the warnings and instructions.
1.1.3 Cleanliness and Good Order
A clean and unobstructed workplace reduces the risk of accident. Always make sure that all
moving parts such as conveyors and screens remain free of any debris. Access to exit doors
and electrical control panels must remain unobstructed at all times. Each operator is
responsible for keeping the workstation clean and in good order.
Water, oil or another liquid can make a floor slippery and cause falls or serious injury. Use
appropriate absorbent to sponge up oil spills and then dispose of the absorbent in a controlled
way. Check local, state and federal laws for the disposal of oil.
1.1.4 Hand Tools and Power Tools
Do not use a pipe to extend a wrench handle. Try penetrating oil.
1.2 Operator Training
The safe and effective use of equipment requires the operator chosen for this specific job to
undergo proper training.
Operator training should include a detailed review of the Operating and Maintenance Manual.
The operator must have access to this manual at all times. Pay special attention to the location
and functions of all controls, protective guards and safety devices, including the emergency-
stop controls. No training is complete without thorough knowledge of the safety
recommendations included in the Operating and Maintenance Manual.
No one takes charge of equipment operations until it is verified that he or she has been fully
trained for the equipment in question.
Summary of Contents for Fingerscreener 206T
