# VSH400PLC090909
- 7 -
Work type selection:
Body: enables bending conductor rails, offsetting, die blanking and forcing in nuts.
Cutting: starts the SH 405 module for rail cutting.
Head: starts the external conduit for powering auxiliary devices with hydraulic oil.
After pressing the Body menu it is necessary to define the reference points on the
measurement bars. The programmer signals it with red areas H, L, A or H, L,
depending on the operation that is being performed.
In order to find them:
H-REF – turn the knob S1 upwards and/or downwards. As a result the red area should
disappear.
L-REF – Move the stop slide S2 from the body to the table end. As a result the red
area should disappear.
A-REF – Bend the angle measurement insert level, the insert must be connected with
the assembly socket. As a result the red area should disappear.
After all these actions have been performed, the station is ready to work.
If only the HEAD (GŁOWICA) or CUTTING (CI
Ę
CIE) menu is used, looking for
reference points is not necessary.
6.2 DIE BLANKING
Die blanking is the default option when you go to the BODY (KORPUS) menu is there
is no equipment in the body.
After starting the BODY (KORPUS) menu, a window will appear where you will have to
define the reference points of the measurement bars (Fig. 5.
Fig. 5.
Fig. 6
For the die blanking operation to be performed correctly, it is necessary:
To determine the distance between the hole centre and the lower rail
edge.
Turn the knob S1 so that the desired offsetting value will be displayed in
area H Fig. 6
To determine the distance between the hole centre and the right rail
edge.
