1 | General information
Erme AG
12 / 66
Table models professional
1.4 Additional sources of information
In addition to the instructions contained in these machine operating instructions, the
information contained in the sources of information specified below must also be
taken into consideration:
– Information about the signage on the machine
– Operating instructions for the assemblies and purchased parts that are in use
– Instructions from the operator
– Safety data sheets for auxiliary and operating materials
– Local accident prevention regulations and regional regulations at the machine
operating site
– Data sheets for installed components
1 Observe the information — in particular, the safety instructions — contained
therein.
1.5 Limitations of liability
All information and instructions provided in these operating instructions were
compiled taking into consideration the applicable standards and regulations, the
technological state-of-the-art as well as knowledge and experience acquired over
many years.
We reserve the right to make technical modifications in the course of further
developing the machine that is the subject of these operating instructions. No claims
can be derived from the information, figures and descriptions provided in these
operating instructions.
The manufacturer assumes no liability for damage and malfunctions due to:
– Non-compliance with these operating instructions
– Unintended use
– Personnel who are not sufficiently trained or trained at all
– Use of impermissible equipment
– Faulty connection
– Non-use of original spare parts and accessories
– Technical modifications and conversions unless they have been coordinated with
the manufacturer
– Non-performance of the required maintenance work
– Performance of welding work on the machine
The manufacturer is liable for any faults or failures on our part, not including further
claims arising within the context of the warranty obligations specified in the
contract. Claims for compensation, regardless of the legal grounds, will be excluded.
