Use and maintenance manual
Auto-Puncher for timing belts
Model: APTM-600
____________________________________________________________________________________________________________________
P a g . 4
-
Transport and unloading the machine
Due to the fragility of some components of the machine, wood packaging is required with
reinforced board to attach it to the base by bolts through the openings in the rubber feet.
To keep the weight of the load well balanced, moving the punch cutting head to halfway across its
run before proceeding to pack is recommended.
For sea transport, the linear rails and drive screw located at the bottom of the cutting head must
be lubricated and full plastic cover provided.
A pallet truck must be used to move the machine, lifting it by the bottom cross bars of the bench
just as shown in the picture.
Fit the four rubber feet and proceed to level.
