Use and maintenance manual
Auto-Puncher for timing belts
Model: APTM-600
____________________________________________________________________________________________________________________
P a g . 8
2. EMERGENCY STOP
This system allows an emergency stop to be performed at any time using the two push buttons
located at both ends of the bench.
Message: EMERGENCY LOCK PUSH BUTTON
To deactivate it, we must unlock the push button and then press RESET to return the head to the
starting point.
2. TREAD BAR
This device does not allow engagement of the cutting head if the bar holding the belt is not
lowered.
Message: TREAD BAR
To deactivate it, all one need do is lower the bar and press START.
3. DOOR OPEN
This device detects that the rear door of the blade head is open.
Message: DOOR OPEN
The door must be closed to deactivate it.
4. CYLINDER DETECTOR
This device does not allow displacement of the head because it detects that the cutting cylinder is
not raised. This may happen due to lack of air or failure of the detector.
Message:
CYLINDER DETECTOR
To deactivate it, provide the machine with air or replace the detector.
Programming.
We must know the functions of the push buttons on the board to program the punch cutter.
