Use and maintenance manual
Longitudinal profile welding
Model: LRW-130
_______________________________________________________________________________________________________________________
P a g . 8
After the welder has been pre-heated, begin welding by turning the control knob (
D
) to start
welder rotation while at the same time pressing the green START button on the control panel to
start the motor.
During the welding process it is always possible to change any of the three settings: temperature,
speed and pressure.
All of these settings have a direct effect on the quality of the weld so a test should be performed
before welding the belt just to make sure all the settings are correct.
The position, angle and proximity of the welder is also very important for the temperature
setting. Increasing the distance or angle in relation to the profile reduces the effectiveness of the
bond between the materials.
Change the position of the welder by first loosening the screws (
R
) and then tightening them
again once it is adjusted:
