Use and maintenance manual
Skiving machine
Model: SK-270
_______________________________________________________________________________________________________________________
P a g . 5
The belt should be passed under the retaining bar up to the edge of the table, adhering the end to
be bevelled on the adhesive tape just at the table end, as shown in the following photo:
Fix the belt in place using the bar by means of the knobs (A) always attempting to maintain
parallelism with the table, in other words, performing this operation on both sides at the same
time and in the same proportion.
We then adjust the bevelling angle as given in the values table (Page 7), releasing the milled knob
towards the outside of the machine as shown in the diagram and turning it to the required point
and then locking it again:
