4
5
RAM
RAM
TAPE MOUNT
• Clean flat surface with alcohol wipe
(A)
• Fit mounting plate
(B)
to mount using
counter sunk screws/holes and nuts
(G)
• Apply adhesive tape
(C)
to mounting
plate and firmly press to surface
PERMANENT MOUNT
Attach mount to dash
using mounting plate
(B)
,
screws and nuts
(H)
.
or
Attach Ehubo to the mount
using screws and washers
(F)
.
Use of the washers is essential to
reliably secure the device!
Route the wiring out of the
way and down the back of the
dashboard.
NOTE: If swapping mounting option do not reuse nyloc nuts, use unused nuts as supplied.
Proceed with
2A
PERMANENT MOUNT
(dashboard)
or
2B TAPE MOUNT
(windshield or flat surface).
1
2B
2A
B
B
C
3
4
Mount the Ehubo
F
H
The Ehubo can be mounted on the dashboard or windshield (where permitted by law where
the vehicle is being operated). For windshield mount or temporary installation on a flat
surface please use the adhesive tape supplied.
NOTE:
Choose the mounting location for your Ehubo carefully and ensure that it complies
with all local regulations. Make sure that the Ehubo does not impair the driver’s visibility,
does not pose a risk in the event of an accident, does not interfere with any systems used
in the operation of the vehicle, does not block or impair the deployment of the airbag, and
has a good view of the sky. Choose a location that does not expose the Ehubo to excessive
temperature or vibration.
G
EROAD Ehubo
(Pre‑fitted Extendable Cable)
EROAD
Fuse kit
(permanent/switched power)
Installation guide
ELD User Manual
+ visor cards
Cable ties
Rear hatch
security plugs
ECM Y cable ‑
included with cable kit
(optional or if required)
Wiring Harness
Cable clamp
Inside the box
Mounting Arm
High–strength adhesive tape
(optional, for tape mount)
Mounting
plate
Screws, nuts and washers
to mount Ehubo
2 x ¾”/ 19mm washers
4 x ½”/ 13mm counter sunk
nyloc nuts
4 x 1”/ 25mm nuts
B
D
E
A
C
TECHNICAL
CLEANING WIPE
Alcohol wipe
F
K
L1
L2
J
I
G
H
Open your Ehubo box and check that everything is inside.
