11
10
Replacement installation
Unpack the
replacement Ehubo
and also place it screen
down on a clean, flat surface.
Make sure to not scratch or damage the screen!
EXISTING EHUBO:
Push down the cable plug latch
to release the cable plug
(V)
and
carefully slide the cable plug off the
internal connector
(W)
.
Remove the rear hatch security plugs
(K)
of both,
the
existing
and the
replacement Ehubo
. This is easily done
by inserting a flathead screwdriver
and scooping out the plug. Unwind
the screw underneath
(S)
.
REPLACEMENT EHUBO:
Carefully insert the cable plug
(V)
into the internal connector
(W)
.
Make sure the cable plug latch clicks
into place to safely secure the plug.
Lift the rear hatch
(T)
off the
existing
Ehubo
and slide it off the cable
grommet
(U)
. Lift the rear hatch off
the
replacement Ehubo
.
Remove the
existing Ehubo
from its mount and carefully
place it screen down on a clean, flat surface.
Make sure to not scratch or damage the screen!
1
2
3
5
4
6
RAM
U
V
W
To replace an existing Ehubo,
• disconnect the power cable from the existing Ehubo and
• connect it to the replacement Ehubo.
Follow these simple steps:
T
K
V
W
S
RAM
Mount the
replacement Ehubo
on the existing mount using the
screws and washers
(F)
supplied with the
replacement Ehubo
.
Insert the two rear hatch
screws
(S)
and new
security plugs
(K)
.
Slide the
replacement Ehubo’s
rear
hatch
(T)
onto the cable grommet
(U)
and
insert it into the
replacement Ehubo
.
Pull the sticker and screen protection film off the Ehubo screen.
Please place the uninstalled Ehubo in the replacement
box and return to EROAD including any surplus parts.
To complete the installation, follow the instructions on the screen.
The install wizard must be re‑run to completion on the new unit.
At the end of the process, when the Ehubo Home screen is
displayed, the installation is complete.
U
T
K
S
F
9
10
11
12
7
8
NOTE:
Turn off
the engine prior to
replacing the Ehubo
