3
R A D I O C O M A N D I
5 - LAYOUT E CONNECTIONS
5.1 - Contacts
terminal 1 =
Contact NO Relay1
terminal 2 =
Contact C Relay1
terminal 3 =
Contact NO Relay2
terminal 4 =
Contact C Relay2
terminal 5 =
Contact NC Relay2
terminal 6 =
Contact NO Relay3
terminal 7 =
Contact C Relay3
terminal 8 =
Contact NO Relay4
terminal 9 =
Contact C Relay4
terminal 10 =
Contact NC Relay4
terminal 11 =
Input supply Common
terminal 12 =
Input 12 Vac/dc
terminal 13 =
Input 24 Vac/dc
terminal 14 =
Pole Antenna
terminal 15 =
GND Antenna
6 - TX PROGRAMMING
Memorizing
The receiver makes the memorization of the transmitters
buttons in sequential way.
Keep the button
P1
pressed down until the red led
DL1
switches on , release
P1
and push the key “A” of the
transmitter ; after push again
P1
, the second red led
DL2
switches on , release
P1
and push the key “B” of the
transmitter. After a while both the led will switch off and the
procedure will be finished. In this way the keys “A” and ”B” of
the transmitter activate the relays K1 and K2 of the receiver.
The procedure to follow for the keys ”C” and “D” is the same
as above. For the memorization of the “C” key on
K3
push
P1
3 times, and for the memorization of the “D” key on K4
push
P1
4 times.
4.2 - Fixing
Remove the receiver cover. T
Fix the box by using the screws and the plugs supplied
At the end place the taps supplied over the holes to
protect the screws head.
80
46
80
Fig. 3
Fig. 4
5.2 - Relay K4 Configuration
The relay K4 can be configured in step mode. Close the
jumper JP1.
1
2 3
4 5
6 7
8 9 10 11 12 13
0 12 24
ac / dc
14 15
K1
K2
K3
K4
JP1
P1
ch1 ch2 ch3 ch4
DL1
DL2
DL3
DL4
JP1 = CLOSED
K4 Pulse
JP1=OPEN
K4 Pulse mode
